Altronix SMP10PMC24X Installation Instructions Bedienungsanleitung PDF herunterladen (Seite 2)

LED Diagnostics:

OLS250/OLS257 - Power Supply Board

Red (DC) Green (AC) Power Supply Status

ON ON Normal operating condition

ON OFF Loss of AC, Stand-by battery supplying power

OFF ON No DC output

OFF OFF Loss of AC. Discharged or no stand-by battery. No DC output.

PD4/PD4CB/PD8/PD8CB - Power Distribution Module

Green Power Distribution Module Status

ON Normal operating condition.

Terminal Identification:

OLS250/OLS257 - Power Supply Board

Terminal Function/Description

Legend

L, G, N Connect 115VAC to these terminals:

L to Hot, N to Neutral, G to ground (if used).

+ DC - 24VDC @ 10 amp continuous outputs.

*AC FAIL Used to notify loss of AC power, e.g. connect to audible device or alarm

N.O., C, N.C. panel. Relay normally energized when AC power is present.

Contact rating 1 amp @ 120VAC / 28VDC

*Low Battery Used to indicate low battery condition, e.g. connect to alarm panel.

N.O., C, N.C. Relay normally energized when DC power is present.

Contact rating 1 amp @ 120VAC / 28VDC

Low battery threshold:

24VDC output threshold set @ approximately 21VDC.

- BAT + Stand-by battery connections. Maximum charge rate .7 amp.

*Note: Supervised Models Only.

PD4/PD4CB/PD8/PD8CB - Power Distribution Module

Terminal Legend Function/

PD4/PD4CB PD8/PD8CB Description

1P to 4P 1P to 8P Positive DC power outputs.

1N to 4N 1N to 8N Negative DC power outputs.

- 2 -

1 2 3 4

Keine Kommentare

Altronix SMP10PMC24X Installation Instructions Bedienungsanleitung Seite 2