
PD4 - Power Distribution Module
Overview:
The PD4 power distribution module converts a single AC or DC input into four (4) individually fused outputs.
Specifications:
Input:
• Handles up to 28VAC/VDC.
Outputs:
• Four (4) individually fused outputs (fuses are rated @ 3.5 amp up to 5 amp fuses may be used)
• Surge suppression.
Visual Indicators:
• Power output LED indicator.
Additional Features:
• Power ON / OFF switch.
Board Dimensions (approximate):
5.25"H x 3.25"W x 1"D
Installation Instructions:
1. Mount PD4 in desired location/enclosure.
2. Connect the desired power supply output to terminals marked [INPUT] (
Fig. 1A).
Note: If using DC voltage, left terminal is NEG. (-) and right terminal is POS. (+) (Fig. 1A).
3. Measure output voltage before connecting devices. This helps avoid potential damage.
All terminals with common suffix P 1P, 2P...” are same polarity.
4. Set power switch [SW1] to the OFF position.
5. Connect each device to terminal pairs 1 to 4, marked [1P-1N thru 4P - 4N].
6. Fuses rated at 3.5A/250V (Replacement fuses can be rated at 5.0 amp).
7. Set power switch [SW1] to the ON position.
INPUT
1P 1N 2P 2N
LED
1P, 2P, 3P, 4P = FUSED OUTPUTS
1N, 2N, 3N, 4N = COMMON OUTPUTS
ON OFF
SW1
F1
3P 3N 4P 4N
F2 F3 F4
NPS
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New
York 11220 USA, 718-567-8181, fax: 718-567-9056
Warranty, Made in U.S.A.
IIPD4 - Rev. 112204
K22D
MEMBER
Fig. 1
INPUT
1P 1N 2P 2N
LED
1P, 2P, 3P, 4P = FUSED OUTPUTS
1N, 2N, 3N, 4N = COMMON OUTPUTS
ON OFF
SW1
F1
3P 3N 4P 4N
F2 F3 F4
NPS
Neg. (
---
)
Pos. (+ )
Fig. 1A
Kommentare zu diesen Handbüchern